null

Made in the USA Since 2006

Gas Tanks

All GenRight Gas Tanks are Made in the USA, hand TIG welded, pressure tested, and CARB compliant (not CARB legal). They utilize your existing factory fuel pump or fuel module, and are 100% bolt in. Most tanks also come with a heavy duty 3/16" powder coated steel skid plate.

  • 100% TIG Welded 1/8" thick aluminum alloy tank.
  • Pressure tested for 24 hours to ensure each and every tank is completely sealed
  • All tanks come with a 3/16" thick steel skid plate (except BST tanks)
  • Accepts the factory fuel pump module (or fuel level sending unit).
  • Reuses all of the factory EVAP connections (no check engine lights).

GenRight's Auxiliary and replacement Fuel Tanks are available in a variety of options.

EXT - Allows for 4-5" of stretch (depending on the axle)

COMP - 6-7" of stretch (depending on the axle)

Enduro - No stretch, 5 gallons over stock

Safari - No stretch, 11 gallons over stock

  • Gas Tank Skid Plate for the Jeep CJ-7 How the skid plate look on Jeep with Leaf Springs

    GenRight

    Crawler™ Skid Plate - CJ

    This is the GenRight Crawler™ Heavy Duty 3/16" thick gas tank skid plate for the Jeep CJ-7 (1974 to 1986). It will fit the stock 20 gallon plastic gas tank or it can be upgraded at a later date to our 20 gallon aluminum Crawler Enduro tank...

    $499.99
  • Fuel Pump Access Panel for the Jeep LJ GenRight's fuel tank access plate is cut into the rear floor section of a Jeep LJ

    GenRight

    Fuel Pump Access Panel for the Jeep LJ

    This is the GenRight Off Road rear floor access plate for the wider floor ribs on the Jeep Wrangler Unlimited LJ (all models 2003 to 2006). It allows you access to the top of the fuel tank (pump, electrical, hoses, vents, etc) without...

    $169.99
  • GenRight Jeep TJ floor plate assembly This is where it is installed in the rear of the cargo area floor of an '05 TJ When the cover plate is installed it only sticks up 1/8" above the top of the ribs in the floor

    GenRight

    Fuel Pump Access Panel for the Jeep TJ, YJ and CJ-7

    This is the GenRight Off Road rear floor access plate/mount for the Jeep Wrangler TJ, Jeep YJ or Jeep CJ-7 (all models 1976 to 2006). It allows you access to the top of the fuel tank (pump, electrical, hoses, vents, etc) without dropping the entire fuel...

    $169.99
  • GST4053 and GST2053 Frame Sleeves w/ Hardware Close up of the sleeve on forward gas tank mount Sleeve shown here on tank mount. Shown here where they would go thru the frame, on each side

    GenRight

    GST4053 and GST2053 Frame Sleeves

    This is the Frame Sleeve kit for the Jeep TJ or YJ. It necessary if bolting up a GenRight gas tank through the factory frame to keep from crushing the frame when tightening to two forward bolts on the skid plate. One sleeve and bolt is used per side...

    $9.99