JK Drive Shaft Upgrade Kit, 4 Door
- Related Products
- Product Videos
- Also Viewed
- By Category
- Other Details
This is the JE Reel Driveshaft UPGRADE for the 4 door Jeep JK (2007 - 2017).
If your JK is lifted more than 2" you should replace the factory "junk" driveshafts.
They are a booted CV style driveshaft and with the increased driveline angle causes the boot to split and allows the joint to run dry.
This is a heavy duty replacement from JE Reel's best 1350 heavy duty set of driveshafts (good for 32 degrees) to fit the factory Rubicon 44's in a 2007 to 2012 Jeep JK 2 door.
Yes, this is the same driveshaft we use on our GenRight JK.
J.E. Reel knows what they are doing, we even run their shafts on our 800HP KOH race buggy!
- Other configurations are also available.
- All good drive shaft kits like this require special Torque Wrench which reads in "inch" pound, to install the new 1350 (non CV style) yoke on the axle side.
Call one of our in-house Jeep experts for more information at 805-584-8635.
Write A Review
The good stuff!
I saw this is the brand the owner runs on his Ultra4 buggy and that was good enough for me! Running a V8 powered JKU and no issues after 3 years.
Anthony from CA
May 15th 2016
Customers Who Viewed This Product Also Viewed
Find Similar Products by Category
Loading... Please wait...