null

MADE IN THE USA

Questions? CALL US 805-584-8635

  • VPP1001 - GenRight Vented Power Steering Pulley The GenRight Underdrive pulley spinning and pushing air over the pump GenRight Vented Power Steering Pulley - Red GenRight Vented Power Steering Pulley - Blue

    GenRight

    Vented Power Steering Pulley

      This is not just eye candy... Big tires and tough trails will make your power steering pump work hard and get incredibly hot! Hot fluid will dramatically shorten the life of the fluid and the pump. GenRight's vented power steering pulley has...

    $199.99
  • GenRight Off Road's Universal Transmission Crossmember Kit Side view of the GenRight cross member holding trans and t-case in a Jeep build. Close up of the Urethane mount & tabs on each side of this universal cross member kit. Weld the tabs to the inside of the frame so there is clearance for your exhaust. GenRight BKT-1050 in '06 LJ Rubicon with the 6 speed manual.

    GenRight

    Universal Transmission Crossmember Kit

      This is a DIY (do-it-yourself) Universal Cross Member Kit to hold up your transmission (or transfer case). We have designed this kit to be compatible with a wide variety of engine and transmission configurations used in off road Jeeps. The...

    $249.99
  • GenRight Twisted Pitman Arm for the Jeep TJ, LJ, YJ Arm is twisted for optimal geometry and range of motion GenRight Twisted Pitman Arm GenRight Twisted Pitman Arm has it's own threaded section for the removal tool Shown here mounted on a Jeep TJ steering box

    GenRight

    GenRight Twisted Pitman Arm

    This is the innovative Twisted Pitman Arm from GenRight Off Road! This will correct the angle issues inherent in hi-steer set ups (on long travel suspension systems using heims). How? We twisted (or rotated) the drag link mounting...

    $399.99
  • This handy bag was made for either swing out or down GenRight tire carrier. Shown here mounted on tire carrier upper hoop with HD velcro. We were able to store the essential trail recovery gear in our PRP tire carrier bag. We tested in harsh conditions.

    GenRight

    Tire Carrier Gear Bag

    This is the GenRight Rear Tire Carrier Gear Bag Tony uses on his Jeep. It is made for us by PRP and is perfect for keeping recovery gear handy out on the trail. We use it to store tow straps, trail gloves, D-ring shackles and...

    $99.99
  • Universal 4 Pass Power Steering Cooler Kit Here you can see how this thin cooler mounts behind the grill

    GenRight

    4 Pass Power Steering Cooler

    This is a 4 Pass cooler (8-1/8" Wide x 5" tall x 3/4" deep), that is an excellent tube-fin heat exchanger, which improves the longevity and overall functioning of your vehicle's power steering system. It installs on the low pressure (return side) of...

    $44.99
  • GenRight Louver for (any) tail gate plate Tailgate Plate NOT Included with the louvered plate, but sold seperatly

    GenRight

    Louver for Tailgate Plate

    This is the Louver made just for the GenRight "Tailgate Plate" from GenRight Off Road. If you are not relocating your license plate to the center of the rear door, this louver simply covers the opening left by the factory...

    $49.99
  • LED Back Up Light (Pair) We used 4 of these in the rear bumper on the GenRight Growler YJ. Here is a good view of the rear bumper plate on the GenRight Bowtie TJ.

    GenRight

    LED Back Up Light (Pair)

      This makes a great Back Up or Rock Light! These clear (or white) LED lights are nearly flush and a clean design! These lights will fit GenRight Jeep Rear Bumpers. This is also great option if you are removing you are...

    $29.99
  • GenRight's 5 piece hood louver set Louvers placement on the hood 5 piece hood vent kit on a Red Jeep Step 1 - tape the mounting surface Step 2 - trace the shape and measure 1/2" in all the way around

    GenRight

    Hood Louver Set, 5pc - Black

    This is the GenRight Off Road 5 piece hood louver set for a Jeep TJ/LJ or YJ in black. This configuration offers maximum cooling for your engine compartment! The louvers can be mounted in many different positions on the hood and (this part number) is...

    $179.99
  • Hood Louver Set, 3pc Short - Black Tony ran the 3 piece louver set on his Growler YJ with a V8 Hood Louver Set, 3pc Short - Black Installed

    GenRight

    Hood Louver Set, 3pc Short - Black

    This is the Gen-Right Off Road 3pc "short" hood louver set.Works great on Jeep TJ, LJ or YJ. They can be mounted in many different positions on the hood and are sold as a 3 piece set.This 3pc kit is: (1) Front louver and (2) short back louvers with...

    $99.99
  • GenRight 3 piece long hood louver set in black Proper hood placement How the underside of the hood looks after mounting Installed on a Jeep Liberty

    GenRight

    Hood Louver Set, 3pc Long - Black

      This is the GenRight Off Road 3pc "long" hood louver set.Works great on Jeep TJ, LJ or YJ.They can be mounted in many different positions on the hood and are sold as a 3 piece set.This 3pc kit is: (1) Front louver has louvers in traditional...

    $99.99
  • Hood Louver Set, 2pc Short - Black

    GenRight

    Hood Louver Set, 2pc Short - Black

    This is the Gen-Right Off Road 2 pc "short" hood louver set for any Jeep or other vehicle with a relativly flat hood.These are intended to be mounted in the rear position on the hood and are sold as a 2 piece set.This 2pc kit is: 2 short louvers,...

    $89.99
  • GenRight's Hood Louver set Here is the typical mounting position for the 2 piece long hood louvers Typical mounting position for the 2 piece long hood louvers

    GenRight

    Hood Louver Set, 2pc Long - Black

    This is the GenRight Off Road 2 piece "long" hood louver set in black. This is a great way to vent that unwanted engine compartment heat and look good too! These louvers can be mounted in many different positions on the hood. Sold as a 2 piece set...

    $89.99
  • Hood Louver Long Front Only Hood Louver Long Front Only

    GenRight

    Hood Louver Long Front Only - Black

    This is the GenRight Off Road "long" FRONT hood louver set in BLACK powder coated finish.Works great on a Jeep TJ, LJ or YJ.This configuration offers great cooling for your engine compartment!The louver can be mounted on front portion of the...

    $59.99
  • 3/16" Aluminum Skins for the Factory Jeep 1/2 doors Close up of door armor on factory Jeep  1/2 door Close up of flush mount hardware on door armor of factory Jeep  1/2 door GenRight door armor on factory Jeep half door Door armor on the GenRight Bowtie Jeep Wrangler TJ

    GenRight

    Jeep TJ & LJ Aluminum Half Door Armor

    This is the GenRight Off Road ALUMINUM Door Armor set for the Jeep hard half doors on a TJ or LJ. These are a direct bolt-on and a perfect upgrade to better protect your Jeep without adding much extra weight! This model is an ideal...

    $399.99
  • Sale
    Rear Support for an Atlas Transfer Case Support Ring on our BKT-1050 cross member kit. Here you can see the support ring installed Holding the rear of the T-case with our double triangulated 4 link rear suspension Holding the rear of the T-case with our double triangulated 4 link rear suspension

    GenRight

    Atlas Transfer Case Support Ring Kit

    This is the GenRight Atlas transfer case rear support. We run this on all our GenRight Jeeps and Ultra4 off-road race cars. Take the stress off the rear section of your (aluminum) transmission housing by supporting the transfer case with this support...

    $199.99
  • Updated design features a rubberized "GR" logo patch Patch detail Great for the driver and passenger! Perfect for leaning out to see where the tire is! Padded arm rest even on JL half doors

    GenRight

    Padded Arm Rest for Half Doors (Pair) Black

      This is the cool Jeep accessory you have been looking for! Tired of leaning your arm on a thin or sharp edged metal half door? These padded arm rests will add a new level of comfort to your next trail ride. It simply fits into the...

    $149.99
  • Aluminum Gas Cap and Filler Kit (Jeep YJ/CJ Pictured) Typical install on a stretched TJ, YJ ot CJ Still easy to access for filling, but recessed so it does not hit the tire Aluminum Gas Cap and Filler Kit (Jeep TJ/LJ '97-'02 Pictured) Kunrled cap for grip, sealed with a premium o-ring to keep dirt out

    GenRight

    Aluminum Gas Cap & Filler Kit w/ Vent

      This is the GenRight Billet Aluminum Gas Cap & Filler assembly. It's compact design solves a problem for stretched Jeeps with big tires! It is mounted above the frame inside the rear inner fender well (as pictured). The entire...

    $299.99
  • GenRight's billet aluminum fairlead Haus for synthetic winch lines Billet aluminum fairlead Haus for use with synthetic winch lines GenRight's billet aluminum fairlead for synthetic winch lines

    GenRight

    GR Aluminum Winch Fairlead

    This is the GenRight Aluminum Winch Fairlead to be used with synthetic winch lines, just like we use on all the GenRight Jeeps.FEATURES  Made from 3/4" thick Aluminum alloy  CNC Machined   Recessed (flush with front...

    $99.99